Category:360 Assembly: Difference between revisions
PatGarrett (talk | contribs) m (→See also) |
(Add Category:Assembler language) |
||
(One intermediate revision by the same user not shown) | |||
Line 1: | Line 1: | ||
{{language}} |
{{language}} |
||
[[Category:Assembly]] |
[[Category:Assembly]] |
||
[[Category:Assembler language]] |
|||
IBM 360 assembly language. |
IBM 360 assembly language. |
||
Line 24: | Line 25: | ||
IBM manuals: |
IBM manuals: |
||
⚫ | |||
* IBM System/360 |
* A Programmer's Introduction to IBM System/360 Assembler Language: http://bitsavers.trailing-edge.com/pdf/ibm/360/asm/SC20-1646-6_int360asm_Aug70.pdf |
||
⚫ |
Latest revision as of 19:51, 12 February 2021
This programming language may be used to instruct a computer to perform a task.
See Also: |
|
---|
IBM 360 assembly language.
From Wikipedia, the free encyclopedia.
ASM360, Assembler 360, 360 assembly, or Basic Assembly Language (BAL) are the commonly used terms for a low-level programming language used on IBM System/360 and successor mainframes. Originally "Basic Assembly Language" applied only to an extremely restricted dialect designed to run under control of IBM Basic Programming Support (BPS/360) on systems with only 8KB of main memory, and only a card reader, a card punch, and a printer for input/output — thus the word "Basic". However, the full name and the initialism "BAL" almost immediately attached themselves in popular use to all assembly-language dialects on the System/360 and its descendants. The 360 assembly was introduced with the System/360 in 1964.
Wikipedia article
IBM Basic assembly language and successors
See also
WikiBooks Article: https://en.wikibooks.org/wiki/360_Assembly/360_Instructions
IBM manuals:
- IBM System/360 Principles of Operation (c. 1963) : http://bitsavers.trailing-edge.com/pdf/ibm/360/princOps/A22-6821-0_360PrincOps.pdf
- A Programmer's Introduction to IBM System/360 Assembler Language: http://bitsavers.trailing-edge.com/pdf/ibm/360/asm/SC20-1646-6_int360asm_Aug70.pdf
Subcategories
This category has the following 2 subcategories, out of 2 total.
3
- 360 Assembly macros (empty)
@
- 360 Assembly User (4 P)
Pages in category "360 Assembly"
The following 20 pages are in this category, out of 220 total.
(previous page) (next page)