View source for Pinstripe/Printer

{{task}}[[Category:Test card]][[Category:Printer]]
The task is to demonstrate the creation of a series of 1 point wide vertical pinstripes with a sufficient number of pinstripes to span the entire width of the printed page (except for the last pinstripe). The pinstripes should alternate one point white, one point black. (Where the printer does not support producing graphics in terms of points, pixels may be substituted in this task.)

After the first inch of printing, we switch to a wider 2 point wide vertical pinstripe pattern. alternating two points white, two points black. We then switch to 3 points wide for the next inch, and then 4 points wide, etc. This trend continues for the entire length of the page (or for 12 inches of run length in the case of a printer using continuous roll stationery). After printing the test pattern the page is ejected (or the test pattern is rolled clear of the printer enclosure, in the case of continuous roll printers).

Note that it is an acceptable solution to use the smallest marks that the language provides, rather than working at native printer resolution, where this is not achievable from within the language.

Optionally, on systems where the printer resolution cannot be determined, it is permissible to prompt the user for printer resolution, and to calculate point size based on user input, enabling fractional point sizes to be used.


=={{header|PicoLisp}}==

<lang PicoLisp>(load "@lib/ps.l")

(call 'lpr
   (pdf "pinstripes"
      (a4)  # 595 x 842 dots
      (for X 595
         (gray (if (bit? 1 X) 0 100)
            (vline X 0 842) ) )
      (page) ) )</lang>

=={{header|Tcl}}==

This code assumes that the page's printable area is 8.5"&times;11".
{{libheader|Tk}}
<lang tcl>package require Tk
# Allocate a temporary drawing surface
canvas .c
# Draw the output we want 
for {set y 0;set dx 1} {$y < 11*72} {incr y 72;incr dx} {
    for {set x 0;set c 0} {$x < 8.5*72} {incr x $dx;set c [expr {!$c}]} {
	.c create rectangle $x $y [expr {$x+$dx+1}] [expr {$y+73}] \
	    -fill [lindex {black white} $c] -outline {}
    }
}
# Send postscript to default printer, scaled 1 pixel -> 1 point
exec lp - << [.c postscript -height $y -width $x -pageheight $y -pagewidth $x]
# Explicit exit; no GUI desired
exit</lang>

{{omit from|Lotus 123 Macro Scripting}}